Flight SAA5BFT

  • Submitted By: Nico De Lange
  • Departure Airport: Athens Eleftherios Venizelos International Airport (LGAV)
  • Arrival Airport: Barcelona Airport (LEBL)
  • Aircraft: A320-232 (ZS-SZC)
  • Flight Time: 02.43
  • Date Submitted: 27/09/2015
  • Route: RILIN UN604 RUTOM UM601 TESPA UM601 NERAR UQ182 MALAV UM601 GINOX UM601 VERSO
  • Status: Accepted
Flight Details
Gross Revenue:
(134 load / R 8,600.00 per unit
R 1,152,400.00
Fuel Cost:
(16594 fuel used @ 7.5 / unit)
R 124,455.00

Additional Log Information:

View Log

smartCARS version 2.1.17.0, 2015-9-27 UTC
[07:58:42] Preflight started, flying offline
[07:58:42] Flying Airbus A320-232 IAE v.2 South African Airways
[07:59:33] Pushing back with 49391 lb of fuel
[07:59:34] Engine 2 is on
[07:59:35] Engine 1 is on
[08:02:02] Taxiing to runway
[08:02:25] Flaps set to position 1
[08:02:27] Flaps set to position 2
[08:11:31] Taking off
[08:12:01] Climbing, pitch: 6, roll: level, 165 kts
[08:12:03] Gear lever raised at 26 ft at 168 kts
[08:12:58] Flaps set to position 1 at 1193 ft at 214 kts
[08:13:24] Flaps set to position 0 at 1740 ft at 230 kts
[08:39:42] Cruising at 34000ft, pitch: 3, 396 kts
[10:30:01] Descending
[10:44:56] Approaching
[10:45:02] Flaps set to position 1 at 6791 ft at 184 kts
[10:47:49] Flaps set to position 2 at 5715 ft at 209 kts
[10:50:40] Flaps set to position 3 at 3002 ft at 177 kts
[10:51:30] Gear lever lowered at 3002 ft at 158 kts
[10:51:47] Final approach, 161 kts
[10:52:21] Flaps set to position 4 at 2421 ft at 152 kts
[10:52:37] Flaps set to position 5 at 2229 ft at 150 kts
[10:55:27] Touched down at -115 fpm, gear lever: down, pitch: 3, roll: level, 143 kts
[10:55:56] Landed in 4753 ft, fuel: 33459 lb, weight: 122713 lb
[10:55:56] Taxiing to gate
[10:56:26] Flaps set to position 0
[11:05:39] The flight may now be ended
[11:05:39] Arrived, flight duration: 02:43
[11:09:39] Engine 2 is off
[11:09:40] Engine 1 is off

Comments

Commenter Comment
Nico De Lange First time using FSX. Went well except fuel consumption. Scalar fuel flow current setting 1.09. Is this correct ???
Ian Carine Hello Nico. Good luck with FSX! I only use the default FSX A321. The default scalar with this is 1. I don't think it can be more than 1 as a higher value INCREASES fuel consumption. You need to use the max range and max fuel capacity for the particular model of a/c you are using to give you an estimated lb/nm consumption figure. I assume a "contingency" has been built into these figures. By comparing actual fuel consumption with this you can adjust the scalar variable until the 2 more or less agree. For the default FSX A321 I use 0.86. Hope this helps. If you need more info send me an e-mail. Regards. Ian

Route Map